Hi everyone! I’m back with a project that I had actually created this past Summer. You know life happened and kept on happening and now has finally (for the moment) settled down. A little back story, me and my Dad a couple of years ago took an old dresser that my husband had wanted to toss and I decided that we, meaning me and my Dad, would cut the dresser down after carefully removing the top of the dresser to reuse. We removed two of the drawers (it had a total of four drawers), add a shelf to create a big opening to store my husband’s not so nice looking lunchbox (I added a curtain to hid said lunchbox) when he wasn’t at work. I have a blog post from when we did this project several years ago if you want to have a look, you can find that blog post HERE, before diving into the diecut storage drawer. (Also that post was on my old blog).
I employed the help of my husband to pull off this project off. The first thing I did with the drawer was sand over the whole area to scuff up the finish.
I used a piece of 21/32″x16″x36″ Paint Grade Wood Panel to replace the bottom of the drawer.
The next thing we did was “punch” out the bottom of the drawer because once you put all those heavy diecuts in the bottom would fall out since it isn’t very thick.
We, meaning my husband, measured and cut the wood panel to fit the bottom of the drawer.
My husband screwed the wood panel to the bottom of the drawer.
Now it’s my time to get to work! I used a spray paint with primer to completely cover, inside and out, the drawer. Side note, next time when I make one of these I will use a brush and paint on the primer because I used a total of three and a half cans of spray paint.
I lightly sanded the knobs that came with the drawer and spray painted those. Another side note, to get an even finish while spray painting I punched holes with my Crop-A-Dile into a piece of corrugated cardboard and screwed the knobs into the cardboard. This keeps the knobs upright and makes it easy to spray paint.
Now I passed the drawer back to my husband so he could add wheels to the bottom of the drawer. My husband marked with a pencil the holes to attach the wheels and drilled tiny holes into wood.
He attached each wheel with washers and screws.
I added the knobs and placed most of my Eileen Hull Diecuts, I have way more that what can fit inside the drawer, and rolled up under the side board I have in my craft room. I hope this inspires everyone to create one for yourselves.
White Spray Paint
21/32″x16″x36″ Paint Grade Wood Panel
Drill and Saw
Washers and Screws
Your Favorite Eileen Hull Diecuts
(Products listed above are Affiliated Links for your convenience)
This blog is compensated to provide opinion on products, services, websites, and various other topics. Even though the owner(s) of this blog receives compensation for our posts or advertisements. I always give my honest opinions, findings, beliefs, or experiences on those topics or products. The views and opinions expressed on this blog are purely my own. Any product claim, statistic, quote or other representation about a product or service should be verified with each manufacturer, provider, or party in question.This blog contains affiliate links, clicking and shopping through these links helps to support and run Tonya Trantham Designs – Creative Paper Addiction at no additional cost to you. Today’s features are Sizzix, Eileen Hull and Scrapbook.com Products.
Thanks for stopping by, hope your Friday is wonderful and enjoy creating!